Fuel Line

Posted on | May 12, 2010 | 2 Comments

Fuel Line

Is disconnecting fuel line from filter for fuel pump diagnosis a proper way to check pump?

I have a 1988 Daytona that isn't getting fuel so I disconnected the fuel line at the filter from the tank to see if the pump was even pumping.Is this an ok method to check the problem or is it just a wasted idea?

The proper way is to install a pressure gage in the line with the line still hooked up. This way you can see if the pressure is up to specs. Disconnecting the line to check for fuel will not tell you if the pressure is good and is dangerous.

Chainsaw Repair Replace Fuel Line

Account limit of 2112 requests per hour exceeded.

7 Steps to Replace Fuel Filters

A little attention and basic knowledge about the fuel supply system will help you follow these Do-It-Yourself (DIY) tips to replace fuel filters easily. When you know that it is time to change the fuel filter, you should also know how to do so. If you don't know how to, read on to find it.

Steps to Replace Worn Out Fuel Filter With New One

First Step – The very first step is to relieve the pressure in your fuel lines and fuel filter. For this you need to start the car first carefully pull the fuel pump fuse or fuel pump relay out. This should be done with engine running. This way you can release all the fuel pressure from the fuel lines. Remember, if you don't release the pressure, explosion can take place while changing fuel filter.

Second Step – The next step is to use wrenches to unbolt the fuel filter fittings. Now try sliding the fuel line off the bolt. Also unscrew the bolt on the other side of the fuel filter. Now that you have taken off the bolts, make sure you keep them properly. You will need them while fixing the new fuel filter.

Third Step – You can now easily remove the old fuel filter. While removing it, you may also find that a small clamp. A screwdriver can be used to release this clamp.

Fourth Step – Closely observe the position of old fuel filter before removing it because you have place the new one in the same position.

Fifth Step – Don't forget to change the washers too. It is important that you change the pressure washer that can be found with the fuel line bolts.

Sixth Step – Now take the new fuel filter and place it at its position. Now just try to snug down the clamps. Fix it properly and tightly so as to prevent any fuel leakage. Also fix the bolts that you had kept aside. Make sure you tighten them properly with the use of wrenches.

Seventh & Last Step – Start the Engine to Check. Once you have replaced the fuel filter, you need to run the car's engine. Now check the fuel filter for any loose connections. Also check for fuel filter seal.

These 7 steps to change or replace fuel filters are easy, but need to be followed carefully. Just change your car's fuel filter to enjoy longer and trouble free drive. Happy Safe Driving!

About the Author

I am Fred Clay, a journalist and an automotive industry expert. Automobiles, automotive parts & components and any & everything related to this industry interests me and is my passion. Over the past eight years, i have covered different automotive industry related news and have been writing on the same. As a professional I have reported on myriad topics, my favorite is the automobile industry. I also write for different web portals and websites. Amongst all, my favorite is Automotive Components & Partsthat is an Automotive industry B2B marketplace. This portal - Automotive-online.com provides detailed information on industry overview, news, trends, professional associations, publications, tenders, product catalogs, international trade leads, trade events, worldwide manufacturers & suppliers related to global automotive components & parts industry. I now blog at: Automobile Hotspot

Comments